型号	F-KL-260C
应用光纤	SM (ITU-T G.652), MM (ITU-T G.651), DS (ITU-T G.653), NZDS (ITU-T G.655)
光纤切割长度	8~16mm （Coating diameter：250µm）    16mm （Coating diameter: 250 ~ 1000µm）
光纤直径	Cladding diameter：80 ~150µm   Coating diameter：100~ 1000μm
光纤数Fiber Count	Single
光纤校准方法	Core aligning
图像处理方法	Analog + Digital
实际平均熔接损失	0.02dB （SM）,  0.01dB (MM),  0.04dB (DS),  0.04dB( NZDS)
熔接时间	Typical 9 sec，with standard SM fiber
熔接模式	12(templet), 188(user)
熔接损失评估	Accurate
回波损耗	＞60dB
Storage of splice result	5000 results   3 parameter per result
Fiber display and magnification	400X（X or Y view），200X（X and Y view）
预热时间Tube heating time	Typical 30 sec
加热模式Tube heating mode	Heating time can be adjusted
加热温度Tube heating temperature	Can not be adjusted
Applicable Protection sleeve length	60mm, 40mm and a series of micro sleeves
拉伸测试Tension test	2N
Electrode life	2500
No.of splice/heating with battery	Typical 150 cycles (splice/tube heat) with inner Li-battery
Display screen	5 inch  color LCD monitor
Image change over	The fiber image is turned upside down
Terminals	RS232
工作状态	0 ~ 5000m above sea level,  0 ~ 95%RH and -10～50℃,  respectively,  Max. wind velocity of 15m/s
电源，功率输出	AC 100-240V with AC adapter;  inner Li-battery(8000mAH)
尺寸	172mm(L) x180mm (W) x145mm (H)
重量	3.6 Kg excluding battery, 4.1Kg including battery

Model	KL-260C
Splicing mode	Auto
Fiber cleaved angle threshold set	0.5 - 8°, 0.5°step
Display fiber cleaved angle	Unavailable
Display fiber offset angle	Unavailable
Auto focusing	Unavailable
Auto aligning	Available
Auto detect cleaved endface fault	Unavailable
Display core offset	Unavailable
Display clad offset	Unavailable
Fiber partial core Compensation	Unavailable
Arc strength automatic adjustment	Unavailable
Display inside temperature	Unavailable
Display ambient temperature	Unavailable
Display heater temperature	Unavailable
Display air pressure	Unavailable
Display battery voltage	Unavailable
Taper Splice	Unavailable
Sleep	Unavailable
Auto Shut down	Unavailable
Software upgrade	Unavailable